If there are no WPS requests within two minutes, it will return to normal modeģ. Enter the Client PIN code on Wireless LAN > WPS page, then click “Start PIN.” After that, the router will activate WPS and wait for the client for two minutes. Here we take Vigor N65 WLAN adapter for example.Ģ. If the Wi-Fi client supports WPS PIN, you may use the WPS with “Client PinCode” for better security. You may check the Wi-Fi clients connected from Wireless LAN > Station List. From the front panel, you will see LED "WLAN" stops flashing, and the LED "ACT" flashes about once per second. After two minutes, the router will turn off WPS automatically. Without entering the Wi-Fi password, the client device will connect to the router after a few seconds.ĥ. (Note: The default SSID of Vigor Wireless Router is “Draytek”, and VigorAP is “Draytek-LAN-A” or “Draytek-LAN-B”.)Ĥ. Now, the WPS-supported clients can join the Wi-Fi network by choosing the router's SSID. It will wait for WPS connections for two minutes.ģ. When WPS is enabled, the LED ACT and WLAN will flash rapidly and synchronously. To turn on WPS, you can press and hold the “Wireless LAN ON/OFF/WPS” button on the front panel, or click "Start PBC" at Wireless LAN > WPS if the router/AP is not physically reachable.Ģ. This article shows how to use WPS in Push Button Method, Client PIN method, and some troubleshooting tips if WPS is not working. However, WPS is disabled by default to protect the wireless network, you'll need to activate first it when the client is ready to connect. Wi-Fi Protected Setup (WPS) allows a wireless device to connect to the password-protected Wi-Fi without the configuration of a password, this is helpful when the device does not have a user-friendly interface.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |